Leon Ridenour also suggested that I modify the oiler so that the gasoline droplets are no so large. One thing I did not do was modify it with a tapered tube as per his instructions. That is not going to be easy as it requires drilling with a very small drill (0.025").
Discovered that I had a leak where the exhaust nipple enters the combustion chamber. I sealed that up with some Permatex thread sealer and tried again to start the engine. I did manage to get it to fire a few times, but the firing was intermittent, and I could not get it to fire often enough to sustain rotation. It seems also, that I was not completely successful sealing that leak. When combustion occurred, a stream of exhaust would spray from a pinhole leak at the threads. I will have to take this apart and try some JB Weld this weekend. Hopefully that works.
Leon Ridenour also suggested that I modify the oiler so that the gasoline droplets are no so large. One thing I did not do was modify it with a tapered tube as per his instructions. That is not going to be easy as it requires drilling with a very small drill (0.025").
0 Comments
This weekend my wife and I showed off the HF1E along with Heron's steam ball at the Toronto Mini Maker Faire. It is estimated that approximately 10,000 people visited the Faire. And it looked like it too. At times the space was packed with people. A fair number of them came and looked (and touched) the engine. I could not demonstrate it running because it was inside, but they got to turn the flywheel and watch the mechanism in action. It's a good thing too, as I have not yet quite got it going. This week I will work on that, but for now it was in good enough shape to show off.
After a brief discussion with Leon Ridenour (the originator of the plans), I decided to get a heavier flywheel. Fortunately, my wife's uncle had an old post drill with a suitable flywheel. We got it off the beast and after painting it, I put it on the HF1e.
I also ordered a proper glass and gaskets for my oiler. Hopefully those arrive early next week. And hopefully, I can get the thing to run. :-) Today, I got the go ahead to display my Henry Ford 1st Engine at the Toronto Maker Faire on the weekend of November 22 and 23rd. SO if you are in the area, please come by and check it out along with a lot of other cool stuff from other Makers.
http://makerfairetoronto.com/maker/2014/charles-baetsen-building-henry-fords-kitchen-engine/ The other day I wired up the HF1E using a modified Model T coil with screw terminals and mounted on the base. I tried starting her on QuickStart the other day, but she did not fire, not even once. After some reading and troubleshooting, I determined that the problem was the exhaust valve. It seems that the valve guide was not allowing it to seat correctly. I drilled a larger hole in the base of it, and that seemed to help. No I can actually feel the compression when I turn it over. However, the plug at the end of the spring gets stuck occasionally and sometimes it still doesn't seat. Despite that, I managed to get a few bangs as I turned it over today, so I know that I am close.
Today I finished up on the mechanical aspects of my replica of Henry Ford's first engine. The last things on my list were to install the valve lifter (tapper) and the piston ring. Now all that remains to to work on the electrical parts.
|
AuthorCharles Baetsen holds a Bachelor and a Master's degree in Engineering Physics from McMaster University in Hamilton, Canada. Archives
February 2024
Categories
All
|